Dual CV 6040
The Dual CV 6040 is a stereo integrated amplifier produced in the late 1980s.
General Specifications
Maximum power (8Ω): 50WFrequency response (-3dB): 10Hz-70kHz
THD+N (1kHz): 0.01%
Signal to noise ratio (Line): 90dB
Signal to noise ratio (MM): 70dB
Crosstalk attenuation: 80dB
Input sensitivity (Line): 200mV
Input sensitivity (MM): 2.5mV
Speaker load impedance: 8Ω-16Ω
Dimensions (WHD): 440×82×245mm
Weight: 5.5kg
Produced: 1989-1992
Initial price: 450DM
Measured Values
Maximum power (8Ω): 43WFrequency response (20Hz-20kHz): ±0.2dB
Channel imbalance: <0.3dB
THD (1kHz, 1W): 0.0022%
THD+N (1kHz, 1W): 0.01%
THD (1kHz, 20W): 0.0016%
THD+N (1kHz, 20W): 0.0061%
IMD (70Hz, 5kHz, 1W): 0.013%
Noise: -60.7dB
Amplification: 103.9
DC offset L: 0.8mV
DC offset R: -1.0mV
Maximum Power
Maximum power is measured using 8Ω resistors on both channels. A 1kHz sine wave input signal is applied and gradually increased until higher harmonics rise significantly. Typically, this is the point at which output clipping occurs.
Frequency Response
Frequency response is measured using several equilizer settings. 'Flat' indicates the tone controls are either turned off or set to their neutral position. 'Max' and 'Min' refer to the maximum and minimum tone control positions, respectively. In the phono section, the expected response follows the RIAA equalization curve.
Residual Noise
These graphs display the noise levels at various volume positions. To eliminate any interference from the input signal, the input lines are shorted during the measurement. Generally, the noise is highest at the mid-point of the volume range (50%)
Distorsion
Total harmonic distortion (THD) is measured using a 1kHz sine wave input, with the output level adjusted to meet different conditions. Intermodulation distortion (IMD) is measured using 'two sine' input signal. THD versus voltage is measured with a 1kHz sine wave input, while THD versus frequency is measured at various output levels.
